How to change RF POWER for zigbee commissioning and after commissioning ?

jylee@kme21.com

How to change RF POWER for zigbee commissioning and after commissioning ?

#define ZB_DEFAULT_TX_POWER_IDX                                        RF_POWER_P10p46dBm

u8 g_zb_txPowerSet = ZB_DEFAULT_TX_POWER_IDX;
u8        g_ble_txPowerSet = ZB_DEFAULT_TX_POWER_IDX;

sampleLight is not searched by Coordinator at 3 meters.
sampleLight is controlled by Coordinator at 3 meters after the sampleLight is commissioned at 2 meters.
How to fix it ?

wes58

Have you tried using:
rf_set_power_level(RF_PowerTypeDef level);
RF_PowerTypeDef is defined if rf_drv.h

jylee@kme21.com

sampleLight is not commissioned by a Coordinator over 3 meters.
sampleLight is controlled by the Coordinator over 3 meters after the sampleLight is commissioned by the Coordinator under 2 meters.
Thus
I think that communication distance is different between "Commissioning" and "after Commissioning".
Can I expand communication distance while commissioning ?

wes58

jylee@kme21.com 发表于 2025-8-20 20:06
sampleLight is not commissioned by a Coordinator over 3 meters.
sampleLight is controlled by the Coo ...

I've never had such problems and my code was based on Telink examples.