What time is until sampleLight (over 40pcs) connect to coordinator ?

jylee@kme21.com · 发表于 2024-12-26 19:46:04

本帖最后由 jylee@kme21.com 于 2024-12-26 19:49 编辑

After I commissioned 1 coordinator and sampleLights(over 40pcs),
I turned off and on the coordinator.
What time is until all sampleLights (over 40pcs) connect to coordinator ?

TL_YB · 发表于 2024-12-27 17:02:15

If ZC communicates with others when powered on, they will immediately trigger a routing request to attempt to restore the link.
If there is no interaction, an attempt will be made when receiving Link Status Command and MTO.

jylee@kme21.com · 发表于 2024-12-30 09:27:05

本帖最后由 jylee@kme21.com 于 2024-12-30 09:44 编辑

TL_YB 发表于 2024-12-27 17:02
If ZC communicates with others when powered on, they will immediately trigger a routing request to a ...

When I use sampleLight (under 30pcs), coordinator communicate without problem.
But When I use sampleLight (over 40pcs), coordinator communicate with problems(some data have timeout).
Each sampleLight have 3 endpoints.(Light Endpoint, Motion Sensor Endpoint, Light Sensor Endpoint).
Do you know why ?

TL_YB · 发表于 2024-12-30 17:42:53

I cannot make a judgment from the above description. Please provide the captured file if possible.

jylee@kme21.com · 发表于 2025-1-13 10:48:30

TL_YB 发表于 2024-12-30 17:42
I cannot make a judgment from the above description. Please provide the captured file if possible.

Are you tested with sampleLight (over 40pcs) ?
1. Commissioning over 40 pcs sampleLight Dongles.
2. Send command bight level and cct value to each sampleLight Dongles sequentially.
=> some dongles will be not connected with coordinator randomly.

TL_YB · 发表于 2025-1-14 09:41:37

jylee@kme21.com · 发表于 2025-1-14 12:56:07

本帖最后由 jylee@kme21.com 于 2025-1-14 18:20 编辑

TL_YB 发表于 2025-1-14 09:41

Did you find the issue ?
Do you have no problems?

TL_YB · 发表于 2025-1-17 15:28:51

The sample light demo looks fine.

		自动登录	找回密码
密码			立即注册