API to put node into unprovisioned state

kaviyarasan · 发表于 2024-12-23 21:43:22

本帖最后由 kaviyarasan 于 2024-12-24 14:28 编辑

1.API to put node into unprovisioned state?

2.in factory_reset() what are data configuration will reset?

3.after did factory reset is there flag to know we did reset?

TL_SHENGFENG · 发表于 2024-12-26 10:28:05

Can you provide a more specific description of your needs

kaviyarasan · 发表于 2024-12-26 12:41:17

TL_HSF 发表于 2024-12-26 10:28
Can you provide a more specific description of your needs

factory_reset() api is not putting the node into unprovisioned state how to put the node into unprovisioned state

TL_SHENGFENG · 发表于 2024-12-26 15:37:20

“Telink SIG MeshSDK Developer Handbook”，You can refer to this document

kaviyarasan · 发表于 2024-12-26 17:38:48

TL_HSF 发表于 2024-12-26 15:37
“Telink SIG MeshSDK Developer Handbook”，You can refer to this document

After did factory reset is there a flag to know now its from factory reset?

TL_SHENGFENG · 发表于 2024-12-26 19:10:20

Following the normal procedure, when factory_reset() is called and the node restart is completed, the node status can be obtained by using get_ provision state

[BLE Mesh] API to put node into unprovisioned state