Some data is not applied in sampleLight module in Zigbee_BLE_Cocurrent_SDK.

jylee@kme21.com · 发表于 2024-10-3 13:31:34

I tested one Cordinator and 10 or more smapleLight (Router mode) module.
When I comissioning and set some data to sampleLight module,
some data is not applied randomly in sampleLight module.
How to reduce data loss for zigbee ?

TL_YANGBIN · 发表于 2024-10-8 17:50:38

Hi,
Can you provide the testing conditions on your side? For example, the number of contracts issued, intervals, etc.

jylee@kme21.com · 发表于 2024-10-29 10:36:03

TL_YB 发表于 2024-10-8 17:50
Hi,
Can you provide the testing conditions on your side? For example, the number of contracts issued ...

1 pcs x Cordinator (Ember Chip)
45 pcs x sampleLight (TLSR8258 chip)

1) Cordinator commission 10 pcs sampleLights
-> When Cordinator send min/max level, color temperature, sensor configurations, and so on then Cordinator communicate with all samleLights correctly.
2) Cordinator commission 20 pcs or more sampleLights
-> When Cordinator send min/max level, color temperature, sensor configurations, and so on then Cordinator communicate with some samleLights correctly but some sampleLights are not communicate with Cordinator.

TL_YANGBIN · 发表于 2024-10-29 19:18:24

jylee@kme21.com 发表于 2024-10-29 10:36
1 pcs x Cordinator (Ember Chip)
45 pcs x sampleLight (TLSR8258 chip)

This requires packet capture analysis to see if there is environmental interference.