using Cmd_download_tool to get flash info

mntdr

Hi everyone,

I'm using Telink BDT v5.8.5 and the command line tool Cmd_download_tool.exe to flash TLSR8258-based devices (via TC32 EVK, Swire interface).

When I use the GUI version of BDT, I Can get this output :

TC32 EVK: Swire ok flash mid = 0x001460c8, flash status = 0x0000, lock area: 0x00000000-0x00000000 flash uid: 41 50 33 32 36 36 32 07 00 c0 00 f3 ff ff ff ff  Total time: 761 ms

However, I’d like to get this same information (flash UID) using the command-line interface (CLI).

I’ve checked the available commands with:

Cmd_download_tool.exe help

and I see options like:

I’m not sure if there is a correct or recommended method to read flash info, or if there’s another CLI command that directly prints the flash MID/UID like the GUI does.

Can anyone from Telink or the community confirm the correct usage or show an example command for reading flash info via CLI?

TL_WMS

The current version of the CLI does not support the flash info command for the time being. This one will be added in the future.

mntdr

TL_WMS 发表于 2025-10-31 16:31
The current version of the CLI does not support the flash info command for the time being. This one  ...

is there a specific place I can read the uid from in the flash ?